Pro-Tech 8 TITAN

MANUFACTURED IN ISO 9001:2000 COMPLIANT FACTORY



The glove shall meet or exceed the NFPA 1971 Standard - 2007 Edition- on Protective Ensemble for Structural Firefighting. Certifying Agent: Safety Equipment Institute McLean, Va.

DESIGN AND FEATURES: Advanced Multi-Layered design using technologically superior light weight components that provide repetitive thermal protection and cut resistance. The unique varied layering design and sewing/construction results in an extremely light weight structural firefighting glove with superior dexterity, comfort, fit and grip without sacrificing NFPA compliant protection and performance.

Five-fingered, winged thumb structure. The back side of the glove features a knuckle guard consisting of 2 layers of waterproof Silicon Carbide fused with 2 layers of 100% Kevlar providing enhanced thermal protection and cut resistance at the traditionally vulnerable knuckle compression point. Gathered stitching is used around the entire wrist for a secure fit and reduces debris from entering the glove.
*The Long Cuff “wristlet” style has a 100% Kevlar wrapped elastic band inside the cuff for extra secure fit and prevention against fire ground debris entering specifically for use with turnout gear that does not have thumb wristlets or long wristlets.
The glove inner liner is sewn in at each fingertip for maximum retention and efficient wet don and doff. A leather hang-up loop is provided on the glove inside for easy drying and storage.

MATERIALS AND LAYERING: The palm side outermost layer is water repellent sueded goat skin tanned and designed to resist cracking, peeling, and stiffening while also providing a sure grip when wet. The ring and middle finger’s suede are cut and sewn independently for enhanced dexterity. Underneath the suede is a full layer of blended 64% KEVLAR / 36% NOMEX and two partial layers of 100% NOMEX both of which which run from the edge of the sueded palm section to the cuff edge. The inner liner on the palm side is another full layer of 100% NOMEX.

The back side of the TITAN outer layer is mainly water repellent goat skin suede which covers the finger tip area, a 1” suede welt across the entire finger crotch area, and the cuff area from the knuckle guard edge to the cuff edge.
Underneath these suede portions on the glove back side is a full layer of 100% KEVLAR and another full layer of 100% NOMEX.
The inner liner on the back side is another layer of 100% NOMEX.

The knuckle guard portion has an outer layer of 100% Kevlar, one layer of 100% Nomex, two layers of silicon carbide paper both fused with 100% Kevlar, another layer of 100% Kevlar and another layer of 100% Nomex representing the inner liner. This unique layered system provides repetitive thermal protection at the most vulnerable spot especially when the fist is clenched whereby the layers of any glove are compressed to reduce protection.
The finger side walls are comprised of an outer layer 64%KEVLAR / 36% NOMEX, and two underneath layers of 100% NOMEX.

The gloves inner layers are fully lined with a double layer of breathable polymer moisture barrier completely sealed in the finger and sidewall area to prevent liquid penetration from the NFPA test chemicals, blood borne pathogens and water. No stitching shall penetrate the membrane and it shall remain flexible in sub zero temperatures.

The glove inner cuff construction is supported by 1½ inch wide leather welting. Identical welting is used additionally within the inner layers of the cuff con- struction, all to prevent moisture wicking and to enhance support and durability.

100% KEVLAR high burst thread and 100% KEVLAR edge piping is used throughout the gloves.


SIZING: The gloves are available from XX Small, Small, Medium, Large, XLarge, XXLarge, XXXLarge, and XXXXLarge.
Cadet models of any sizes with ½” shorter finger lengths are available upon request.

QUANTITY DISCOUNTS AVAILABLE